Skip to main content

Reply to "1232 SP and Envelopes"

Brian:

The 1224 and 1232, I forgot to attach the attachment. Will have it later today!

Art

B051/B052
Envelope feeding from the Bypass Tray



Note the correction position for envelope printing.


Place the envelope in the tray LEF (9 1/2 edge first); feed paper from the flap side up in thick mode. (The flap should be feed last and open see above)

Do not load more then 5 envelopes at one time.

Go to user tools/ printer features/ paper input/bypass paper size/next, than select 4 1/8 x 9 ½
and exit user tools. This will set the bypass for Com 10 envelopes for the printer only.


­ Setting up envelopes in WORD 2000

In Word 2000, select file, page setup / page size tab and scroll paper size to Com 10 envelope/ select landscape in orientation and change margins in the margin tab. If this is something the customer will use often have the customer create an envelope.dot file and put this file in the Microsoft Template folder. The printer MUST be set for bypass 4 1/8 x 9 ½ thick mode. The printer does not have to be the default printer, however if you select the pcl driver you must check rotate under the setup tab in the driver settings then click apply after envelope is printing is complete remember to deselect rotate. If you select the RPCS driver set new icon for envelopes - set the bypass on thick mode as the default for that icon, rotate does not need to be selected.

-Or-

In Word 2000 select file then new. Then select the “Letters & Faxes” tab in “new office doc wizard”, select Envelope Wizard, and follow the wizard. If this method is used you must have the B051/B052 as the default printer and it is not necessary to change the bypass size on the printer (B051/B052).

The following envelopes have been tested successfully through the bypass of the UC1.

Quality Park Traditional Business Envelope #11112
Quality Park Laser/IJ Business Envelope #11184
Westvaco Laser Quality Envelope CO130
Westvaco Laser Quality Envelope CO125

[This message was edited by Docusultant on Thu December 18 2003 at 01:51 PM.]
×
×
×
×
×